
The full auto Talon ambidextrous safety selector is designed for use in fully automatic lower receivers, and has a “Safe” 0 degree position, 90 degree “Semi Auto” position, and 180 degree “Full Auto” position. The Full Auto Talon features ergonomic levers that are attached using a precision-machined dovetail interface and spring-loaded retention studs to lock the levers in place – no screws to come loose or break. The left side long lever is permanently affixed to the steel selector shaft while the short lever can be removed using the supplied L shaped detent tool.
Levers Machined from Aircraft-Grade Aluminum with MIL-SPEC Type III Hard Anodized Finish.
STEP 01 | Remove the grip and old safety.
STEP 02 | Apply a light coating of oil to the Talon cylinder and insert into the lower receiver so the detent groove in the shaft lines with the safety detent hole.
STEP 03 | Drop the supplied safety detent into the lower receiver and place the supplied safety detent spring into the grip. Install and tighten the grip.
STEP 04 | Snap the small spring included in the parts kit onto the shorter end of the retention stud.
STEP 05 | Insert the spring loaded retention stud into the hole at the end of the cylinder, spring end first.
STEP 06 | Using the supplied Talon installation tool, depress the spring loaded retention stud while sliding the lever onto the dovetail. The retention stud will snap into place securing the lever.
Repeat Steps 04-06 for the second lever to complete installation.
HOW TO SWITCH THROW CONFIGURATION
STEP 01 | Loosen the grip just enough to rotate the entire safety unit 180°, then tighten grip.
STEP 02 | Remove the levers using the supplied installation tool, then reinstall the levers in the correct orientation.
1 - TALON-FA Cylinder
1 - Short Lever
1 - Long Lever
2 - TALON Spring & Detents
1 - Talon Tool
1 - Safety Selector Detent
1 - Safety Selector Detent Spring
The Talon is compatible with most low shelf automatic AR15 & AR10/SR25-pattern rifles.
8BMX3